Cisco ASR 1000 Series Software Configuration Guide

ModificationRelease
The show voice dsp group all command output was
modified for SPA-DSP on the Cisco ASR 1000 Series
Aggregation Services Routers.
Cisco IOS XE Release 3.3.0S
Introduced a new DSP SPA, for the ASR 1000 Series
to enable transcoding and transrating services for
voice.
Cisco IOS XE Release 3.2.0S
Prerequisites
The following table is the software and hardware compatibility requirement matrix for installing a SPA-DSP:
Table 39: SPA-DSP Hardware and Software Requirements
Minimum Cisco
IOS XE Software
Release
supported
ESPs supportedSIPs supportedRoute Processor
supported
ASR1000 Router
Chassis
supported
Type of DSP
SPA (Product ID)
Cisco IOS XE
Release 3.2s
ESP10, ESP40,
and ESP100
SIP10 and
SIP40
RP1 and RP2ASR 1002, ASR
1002-X, ASR
1004, and ASR
1006
SPA-DSP
Rules for Installing SPA-DSP
This section provides detailed information about the rules for installing SPA-DSP on Cisco ASR 1000 Series
Aggregation Services Routers. For installing a SPA-DSP, you need to adhere to the following rules.
1
The Cisco ASR 1000 Series Aggregation Services Routers must be installed with Advanced Enterprise
Services K9 (AESK9) only. The following table provides details regarding the feature set, Universal
Software Image Part Number, and Technology Package License Part Number required for installation of
SPA-DSP.
2
Requires Cisco IOS XE Release 3.3.0S or later for all Cisco ASR 1000 Series Aggregation Services
Routers including the Cisco ASR 1001 Router.
3
Requires one CUBE feature license.
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
398 OL-14127-17
Overview of the Cisco DSP SPA for the ASR 1000 Series Aggregation Services Routers
Prerequisites

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English