Cisco ASR 1000 Series Software Configuration Guide

CHAPTER 15
Configuring the 8-Port Channelized T1/E1 Serial
SPA
This chapter provides information about configuring the 8-Port Channelized T1/E1 Serial SPA on the Cisco
ASR 1000 Series Routers.
•
Configuration Tasks, page 223
•
Verifying the Interface Configuration, page 234
•
Configuration Examples, page 234
Configuration Tasks
This section describes how to configure the 8-Port Channelized T1/E1 Serial SPA for the Cisco ASR 1000
Series Routers and verify the configuration. For information about managing your system images and
configuration files, refer to the following:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
•
Cisco IOS Configuration Fundamentals Configuration Guide
•
Cisco IOS Configuration Fundamentals Command Reference
Required Configuration Tasks
This section lists the required configuration steps to configure the 8-Port Channelized T1/E1 Serial SPA.
Some of the required configuration commands implement default values that might be appropriate for your
network. If the default value is correct for your network, then you do not need to configure the command.
To better understand the address format used to specify the physical location of the SIP, SPA, and interfaces,
see the Specifying the Interface Address on a SPA, on page 228.
Note
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS XE
Everest 16.5
OL-14127-17 223

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English