PurposeCommand or Action
Exits the ATM VC interface configuration mode and returns to the
privileged EXEC mode.
Router(config-if-atm-vc)# end
Step 8
Sample Configuration
The following example shows how to configure a Layer 3 QOS on the CEoP SPA:
Router# configure terminal
Router(config)# interface atm 3/0/0.1 point-to-point
Router(config-if)# ip address 24.0.0.1 255.255.255.0
Router(config-if)# pvc 1/40
Router(config-if-atm-vc)# service-policy in omni_flat_ingress10
Router(config-if-atm-vc)# service-policy out flat_brr10
Router(config-if-atm-vc)# end
Verifying the Configuration
The following example shows how to verify the configuration:
Router# show policy-map interface cem3/0/0.1/1/1
CEM3/0/0.1/1/1: VC 1/40 -
Service-policy input: omni_flat_ingress10
Counters last updated 00:00:03 ago
Class-map: prec4 (match-all)
0 packets, 0 bytes
30 second offered rate 0000 bps, drop rate 0000 bps
Match: precedence 4 police:
cir 52500 bps, bc 4470 bytes
conformed 0 packets, 0 bytes; actions:
transmit
exceeded 0 packets, 0 bytes; actions:
drop
conformed 0000 bps, exceeded 0000 bps
Class-map: prec5 (match-all)
0 packets, 0 bytes
30 second offered rate 0000 bps, drop rate 0000 bps
Match: precedence 5
police:
cir 54000 bps, bc 4470 bytes
conformed 0 packets, 0 bytes; actions:
transmit
exceeded 0 packets, 0 bytes; actions:
drop
conformed 0000 bps, exceeded 0000 bps
Class-map: prec6 (match-all)
391 packets, 29584 bytes
30 second offered rate 0000 bps, drop rate 0000 bps
Match: precedence 6
police:
cir 56000 bps, bc 4470 bytes
conformed 391 packets, 29584 bytes; actions:
transmit
exceeded 0 packets, 0 bytes; actions:
drop
conformed 0000 bps, exceeded 0000 bps
Class-map: class-default (match-any)
255775 packets, 194214265 bytes
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
536 OL-14127-17
Configuring the Circuit Emulation over Packet Shared Port Adapter
Sample Configuration
To Next Page
Loading...
Need help?
General
