Cisco ASR 1000 Series Software Configuration Guide

SUMMARY STEPS
1.
Router(config)# controller t1 slot/subslot/port
2.
Router(config-controller)# [no] cem-group group-number {unframed | timeslots timeslot}
3.
Router(config-controller)# framing {sf | esf}
4.
Router(config-controller)# exit
5.
Router(config)# interface cem slot/subslot/port
6.
Router(config-controller)# cem group-number
7.
Router(config-controller)# xconnect peer-ip-address encap mpls
8.
Router(config-controller)# exit
DETAILED STEPS
PurposeCommand or Action
Selects the T1 controller.
Router(config)# controller t1 slot/subslot/port
Step 1
Creates a CEM interface and assigns it to a CEM group
number.
Router(config-controller)# [no] cem-group
group-number {unframed | timeslots timeslot}
Step 2
Selects the T1 framing type.Router(config-controller)# framing {sf | esf}
Step 3
Exits the controller configuration (config-controller)
mode and returns to the global configuration (config)
mode.
Router(config-controller)# exit
Step 4
Selects the CEM interface.
Router(config)# interface cem slot/subslot/port
Step 5
Selects the specified CEM group.
Router(config-controller)# cem group-number
Step 6
Configures a pseudowire for the T1 timeslot identified
by the CEM group.
Router(config-controller)# xconnect peer-ip-address
encap mpls
Step 7
Exits the controller configuration (config-controller)
mode.
Router(config-controller)# exit
Step 8
Configuring E1 on a 24-Port Channelized T1/E1 ATM CEoP SPA
To configure E1 on a 24-Port Channelized T1/E1 ATM CEoP SPA, perform the following steps:
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
508 OL-14127-17
Configuring the Circuit Emulation over Packet Shared Port Adapter
Configuring E1 on a 24-Port Channelized T1/E1 ATM CEoP SPA

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English