Cisco ASR 1000 Series Software Configuration Guide

Reactivating a SIP
If you did deactivate the SIP using the hw-module slot stop command, then you do not need to reactivate the
SPAs after an OIR of the SIP. The installed SPAs automatically reactivate upon reactivation of the SIP in the
Cisco Aggregation Services Router 1000 Series.
For example, consider the case where you remove a SIP from the Cisco Aggregation Services Router 1000
Series to replace it with another SIP. You reinstall the same SPAs into the new SIP. When you enter the
hw-module slot start command on the Cisco Aggregation Services Router 1000 Series, the SPAs automatically
reactivate with the new SIP.
To activate a SIP and its installed SPAs after the SIP has been deactivated, use the following command in
global configuration mode:
PurposeCommand
Activates the SIP in the specified slot and its installed
SPAs.
• slot-number—Specifies the chassis slot number
where the SIP is installed
• start—Activates the SIP and removes it from
reset mode
Router(config)# hw-module slot slot-number start
For more information about chassis slot numbering, see the “Identifying Slots and Subslots for the SIPs and
SPAs” section in the Configuring the SIP chapter.
Verifying the Deactivation and Activation of a SIP
To verify the deactivation of a SIP, enter the show platform command in privileged EXEC configuration
mode. Observe the State field associated with the SIP that you want to verify.
The following example shows that the Cisco ASR1000-SIP10 located in slot 1 is deactivated.
Router# show platform
Chassis type: ASR1006
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ASR1000-SIP10 ok 2d20h
0/0 SPA-1XOC12-POS ok 2d20h
0/1 SPA-1XOC12-POS ok 1d21h
0/2 SPA-5X1GE-V2 ok 2d20h
0/3 SPA-4XOC3-POS-V2 ok 2d20h
1 ASR1000-SIP10 disabled 1d23h
R0 ASR1000-RP1 ok, active 1w3d
F0 ASR1000-ESP10 ok, active 1w3d
P0 Unknown ps, fail never
P1 Unknown ps, fail never
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 06120701 12.2(20071009:051408) [gschnorr-mcp_...
1 07091401 12.2(20070807:170946) [gschnorr-mcp_...
R0 07010515 12.2(33r)XN2
F0 07021400 12.2(20071030:180953) [gschnorr-mcp_...
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
40 OL-14127-17
Troubleshooting the SIP
Verifying the Deactivation and Activation of a SIP

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English