11-18
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 11 Configuring Multicast Routing
Configuring PIM Features
To configure a static multicast route for PIM, enter the following command:
hostname(config)# mroute src_ip src_mask input_if_name [distance]
To configure a static multicast route for a stub area, enter the following command:
hostname(config)# mroute src_ip src_mask input_if_name [dense output_if_name] [distance]
Note The dense output_if_name keyword and argument pair is only supported for stub multicast routing.
Configuring PIM Features
Routers use PIM to maintain forwarding tables for forwarding multicast diagrams. When you enable
multicast routing on the security appliance, PIM and IGMP are automatically enabled on all interfaces.
Note PIM is not supported with PAT. The PIM protocol does not use ports and PAT only works with protocols
that use ports.
This section describes how to configure optional PIM settings. This section includes the following
topics:
• Disabling PIM on an Interface, page 11-18
• Configuring a Static Rendezvous Point Address, page 11-19
• Configuring the Designated Router Priority, page 11-19
• Filtering PIM Register Messages, page 11-19
• Configuring PIM Message Intervals, page 11-19
• Configuring a Multicast Boundary, page 11-20
• Filtering PIM Neighbors, page 11-20
• Supporting Mixed Bidirctional/Sparse-Mode PIM Networks, page 11-21
Disabling PIM on an Interface
You can disable PIM on specific interfaces. To disable PIM on an interface, enter the following
command:
hostname(config-if)# no pim
To reenable PIM on an interface, enter the following command:
hostname(config-if)# pim
Note Only the no pim command appears in the interface configuration.
To Next Page
Loading...
Need help?
General