Cisco FirePOWER ASA 5500 series User Manual

12-12
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 12 Configuring IPv6
Verifying the IPv6 Configuration
• The multicast groups the interface belongs to.
• ICMP redirect and error message settings.
• Neighbor discovery settings.
The following is sample output from the show ipv6 interface command:
hostname# show ipv6 interface
ipv6interface is down, line protocol is down
IPv6 is enabled, link-local address is fe80::20d:88ff:feee:6a82 [TENTATIVE]
No global unicast address is configured
Joined group address(es):
ff02::1
ff02::1:ffee:6a82
ICMP error messages limited to one every 100 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
Note The show interface command only displays the IPv4 settings for an interface. To see the IPv6
configuration on an interface, you need to use the show ipv6 interface command. The show ipv6
interface command does not display any IPv4 settings for the interface (if both types of addresses are
configured on the interface).
The show ipv6 route Command
To display the routes in the IPv6 routing table, enter the following command:
hostname# show ipv6 route
The output from the show ipv6 route command is similar to the IPv4 show route command. It displays
the following information:
• The protocol that derived the route.
• The IPv6 prefix of the remote network.
• The administrative distance and metric for the route.
• The address of the next-hop router.
• The interface through which the next hop router to the specified network is reached.
The following is sample output from the show ipv6 route command:
hostname# show ipv6 route
IPv6 Routing Table - 7 entries
Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP
U - Per-user Static route
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea
O - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2
L fe80::/10 [0/0]
via ::, inside
L fec0::a:0:0:a0a:a70/128 [0/0]
via ::, inside
C fec0:0:0:a::/64 [0/0]
via ::, inside
L ff00::/8 [0/0]
via ::, inside

Cisco FirePOWER ASA 5500 series Specifications

General

Brand	Cisco
Model	FirePOWER ASA 5500 series
Category	Firewall
Language	English