14-45
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 14 Configuring Failover
Configuring Failover
Viewing Monitored Interfaces
To view the status of monitored interfaces, enter the following command. In single context mode, enter
this command in global configuration mode. In multiple context mode, enter this command within a
context.
primary/context(config)# show monitor-interface
For example:
hostname/context(config)# show monitor-interface
This host: Primary - Active
Interface outside (192.168.1.2): Normal
Interface inside (10.1.1.91): Normal
Other host: Secondary - Standby
Interface outside (192.168.1.3): Normal
Interface inside (10.1.1.100): Normal
Displaying the Failover Commands in the Running Configuration
To view the failover commands in the running configuration, enter the following command:
hostname(config)# show running-config failover
All of the failover commands are displayed. On units running multiple context mode, enter this command
in the system execution space. Entering show running-config all failover displays the failover
commands in the running configuration and includes commands for which you have not changed the
default value.
VPN IPSEC upd IPSec connection information.
VPN CTCP upd cTCP tunnel connection information.
VPN SDI upd SDI AAA connection information.
VPN DHCP upd Tunneled DHCP connection information.
GTP PDP GTP PDP update information. This information appears only if inspect
GTP is enabled.
GTP PDPMCB GTP PDPMCB update information. This information appears only if
inspect GTP is enabled.
Logical Update Queue
Information
For each field type, the following statistics are used:
• Cur—Current number of packets
• Max—Maximum number of packets
• Total—Total number of packets
Recv Q The status of the receive queue.
Xmit Q The status of the transmit queue.
Table 14-8 Show Failover Display Description (continued)
Field Options
To Next Page
Loading...
Need help?
General