Cisco FirePOWER ASA 5500 series User Manual

25-66
Cisco Security Appliance Command Line Configuration Guide
OL-10088-01
Chapter 25 Configuring Application Layer Protocol Inspection
SIP Inspection
d. To enable check on Max-forwards header field being 0 (which cannot be 0 before reaching the
destination), enter the following command:
hostname(config-pmap-p)# max-forwards-validation action {drop | drop-connection |
reset | log} [log]
e. To enable check on RTP packets flowing on the pinholes for protocol conformance, enter the
following command:
hostname(config-pmap-p)# rtp-conformance [enforce-payloadtype]
Where the enforce-payloadtype keyword enforces the payload type to be audio or video based on
the signaling exchange.
f. To identify the Server and User-Agent header fields, which expose the software version of either a
server or an endpoint, enter the following command:
hostname(config-pmap-p)# software-version action {mask | log} [log]
Where the mask keyword masks the software version in the SIP messages.
g. To enable state checking validation, enter the following command:
hostname(config-pmap-p)# state-checking action {drop | drop-connection | reset | log}
[log]
h. To enable strict verification of the header fields in the SIP messages according to RFC 3261, enter
the following command:
hostname(config-pmap-p)# strict-header-validation action {drop | drop-connection |
reset | log} [log]
i. To allow non SIP traffic using the well-known SIP signaling port, enter the following command:
hostname(config-pmap-p)# traffic-non-sip
j. To identify the non-SIP URIs present in the Alert-Info and Call-Info header fields, enter the
following command:
hostname(config-pmap-p)# uri-non-sip action {mask | log} [log]
The following example shows how to disable instant messaging over SIP:
hostname(config)# policy-map type inspect sip mymap
hostname(config-pmap)# parameters
hostname(config-pmap-p)# no im
hostname(config)# policy-map global_policy
hostname(config-pmap)# class inspection_default
hostname(config-pmap-c)# inspect sip mymap
hostname(config)# service-policy global_policy global
Configuring SIP Timeout Values
The media connections are torn down within two minutes after the connection becomes idle. This is,
however, a configurable timeout and can be set for a shorter or longer period of time. To configure the
timeout for the SIP control connection, enter the following command:
hostname(config)# timeout sip hh:mm:ss

Cisco FirePOWER ASA 5500 series Specifications

General

Brand	Cisco
Model	FirePOWER ASA 5500 series
Category	Firewall
Language	English