Cisco XR 1200 series User Manual

access-list
To specify an access-list name to filter provider edge (PE) addresses to restrict operations that are automatically
created by MPLS LSP monitor (MPLSLM) instance, use the access-list command in the appropriate
configuration mode. To return to the default value, use the no form of this command.
access-list acl-name
no access-list
Syntax Description
Filters an access-list name.
acl-name
Command Default
No access list is configured by default.
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
ModificationRelease
This command was introduced.Release 3.6.0
Usage Guidelines
Access-list changes are processed before the scan interval expires to display a planned list of changes in the
scan-queue.
There is no verification check between the access list and the IPSLA configuration.Note
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the access-list command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 115
IP Service Level Agreement Commands
access-list

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English