Cisco XR 1200 series User Manual

logging events link-status (interface)
To enable the logging of link-status system logging (syslog) messages on a specific interface for virtual
interfaces and subinterfaces, use the logging events link-status command in the appropriate interface or
subinterface mode. To disable the logging of link status messages, use the no form of this command.
logging events link-status
no logging events link-status
Syntax Description
This command has no keywords or arguments.
Command Default
The logging of link-status messages is disabled for virtual interfaces and subinterfaces.
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
When the logging of link-status messages is enabled, the router can generate a high volume of link-status up
and down system logging messages. The logging events link-status command enables messages for virtual
interfaces and subinterfaces only.
The logging events link-status command allows you to enable and disable logging on a specific interface
for bundles, tunnels, and VLANs.
Use the no logging events link-status command to disable the logging of link-status messages.
Enabling the logging events link-status command on a specific interface overrides the global configuration
set using the logging events link-status, on page 317 command in global configuration mode.
Note
Task ID
OperationsTask ID
read, writelogging
Examples
This example shows the results of turning on logging for a bundle interface:
RP/0/0/CPU0:router(config)# int bundle-pos 1
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 319
Logging Services Commands
logging events link-status (interface)

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English