logging console
To enable logging of system logging (syslog) messages logged to the console by severity level, use the logging
console command in global configuration mode. To return console logging to the default setting, use the no
form of this command.
logging console {severity| disable}
no logging console
Syntax Description
Severity level of messages logged to the console, including events of a higher severity
level (numerically lower). The default is informational. Settings for the severity levels
and their respective system conditions are listed in Table 29: Severity Levels for Messages,
on page 312 under the “Usage Guidelines” section for the logging buffered, on page 312
command.
severity
Removes the logging console command from the configuration file and disables logging
to the console terminal.
disable
Command Default
By default, logging to the console is enabled.
severity: informational
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
Added the disable keyword.
The command no logging console was changed to reset console
logging to the default setting.
Release 3.3.0
Usage Guidelines
Use the logging console command to prevent debugging messages from flooding your screen.
The logging console is for the console terminal. The value specified for the severity argument causes messages
at that level and at numerically lower levels (higher severity levels) to be displayed on the console.
Use the logging console disable command to disable console logging completely.
Use the no logging console command to return the configuration to the default setting.
Use the show logging, on page 344 command to display syslog messages stored in the logging buffer.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
314 OL-24735-01
Logging Services Commands
logging console
To Next Page
Loading...
Need help?
General
