Cisco XR 1200 series User Manual

scan interval
To specify the frequency at which the MPLS LSP monitor (MPLSLM) instance checks the scan queue for
updates, use the scan interval command in the appropriate configuration mode. To return to the default value,
use the no form of this command.
scan interval scan-interval
no scan interval
Syntax Description
Time interval between provider edge (PE) router updates. Range is
1 to 70560.
scan-interval
Command Default
interval: 240 minutes
Command Modes
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
Use the scan interval command to specify a frequency value in minutes at which the MPLS LSP monitoring
instance checks the scan queue for PE updates. Updates from PE discovery are not processed immediately,
but rather stored in a scan queue for batched processing at periodic intervals, specified by this value.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the scan command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-ping)# scan interval 120
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 211
IP Service Level Agreement Commands
scan interval

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English