Cisco XR 1200 series User Manual

output interface
To specify the echo request output interface to be used for LSP ping or LSP trace operations, use the output
interface command in IP SLA MPLS LSP ping or IP SLA MPLS LSP trace configuration mode. To return
the output interface to the default, use the no form of this command.
output interface type interface-path-id
no output interface
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
No default behavior or values.
Command Modes
IP SLA MPLS LSP ping configuration
IP SLA MPLS LSP trace configuration
IP SLA MPLS LSP monitor ping configuration
IP SLA MPLS LSP monitor trace configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
Use the output interface command to help monitor path-to-target over the path if there are some ECMP
routes in a topology.
You cannot use the output interface command if pseudowire is specified as the target to be used in an MPLS
LSP ping operation.
Task ID
OperationsTask ID
read, writemonitor
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 175
IP Service Level Agreement Commands
output interface

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English