event manager environment
To set an Embedded Event Manager (EEM) environment variable, use the event manager environment
command in global configuration mode. To remove the configuration, use the no form of this command.
event manager environment var-name [ var-value ]
no event manager environment var-name
Syntax Description
Name assigned to the EEM environment configuration variable.
var-name
(Optional) Series of characters, including embedded spaces, to be placed in the
environment variable var-name.
var-value
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
The fault manager environment command was replaced with the event
manager environment command.
The var-value argument was changed from required to optional.
Release 3.6.0
Task ID was changed from fault-mgr to eem.Release 3.7.0
Usage Guidelines
Environment variables are available to EEM policies when you set the variables using the event manager
environment command. They become unavailable when you remove them with the no form of this command.
By convention, the names of all the environment variables defined by Cisco begin with an underscore character
(_) to set them apart, for example, _show_cmd.
Spaces can be used in the var-value argument. This command interprets everything after the var-name argument
uptil the end of the line in order to be a part of the var-value argument.
Use the show event manager environment, on page 92 command to display the name and value of all EEM
environment variables before and after they have been set using the event manager environment command.
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
80 OL-24735-01
Embedded Event Manager Commands
event manager environment
To Next Page
Loading...
Need help?
General
