Cisco XR 1200 series User Manual

packet interval
To specify the interval between packets, use the packet interval command in the appropriate configuration
mode. To use the default value, use the no form of this command.
packet interval interval
no packet interval
Syntax Description
Interpacket interval in milliseconds. Range is 1 to 60000 (in milliseconds).
interval
Command Default
The default packet interval is 20 ms.
Command Modes
IP SLA UDP jitter configuration
IP SLA ICMP path-jitter configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the packet interval command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# packet interval 30
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 181
IP Service Level Agreement Commands
packet interval

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English