Cisco XR 1200 series User Manual

mpls discovery vpn
To configure MPLS label switched path (LSP) provider edge (PE) router discovery, use the mpls discovery
vpn command in IP SLA configuration mode. To use the default value, use the no form of this command.
mpls discovery vpn [interval interval]
no mpls discovery vpn
Syntax Description
Configures the refresh interval for MPLS label switched path (LSP) monitoring.interval
Command Default
None
Command Modes
IP SLA configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
Use the mpls discovery vpn command to configure provider edge (PE) router discovery. PE Discovery
discovers the LSPs used to reach every routing next hop. Routing entities are stored in a Layer 3 VPN discover
database.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to enter IP SLA MPLS discovery VPN mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls discovery vpn
RP/0/0/CPU0:router(config-ipsla-mpls-discovery-vpn)#
Related Commands
DescriptionCommand
Configures the refresh interval for MPLS label
switched path (LSP) monitoring.
interval, on page 148
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
170 OL-24735-01
IP Service Level Agreement Commands
mpls discovery vpn

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English