Cisco XR 1200 series User Manual

threshold type xofy
To take action upon X violations in Y probe operations, use the threshold type xofy command in IP SLA
reaction condition configuration mode. To clear the threshold type (reaction will never happen), use the no
form of this command.
threshold type xofy x-value y-value
no threshold type
Syntax Description
When the reaction conditions, such as threshold violations, are met for the monitored
element after some x number of violations within some other y number of probe
operations (for example, x of y), the action is performed as defined by the action
command. Default is 5 for both x-value and y-value; for example, xofy 5 5. Range is 1
to 16.
x-value y-value
Command Default
If there is no default value, no threshold type is configured.
Command Modes
IP SLA reaction condition configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the threshold type xofy command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# reaction operation 432
RP/0/0/CPU0:router(config-ipsla-react)# react verify-error
RP/0/0/CPU0:router(config-ipsla-react-cond)# threshold type xofy 1 5
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 275
IP Service Level Agreement Commands
threshold type xofy

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English