Cisco XR 1200 series User Manual

logging events level
To specify a severity level for logging alarm messages, use the logging events level command in global
configuration mode. To return to the default value, use the no form of this command.
logging events level severity
no logging events level
Syntax Description
Severity level of events to be logged in the logging events buffer, including events of a
higher severity level (numerically lower). Table 2: Alarm Severity Levels for Event
Logging, on page 31lists severity levels and their respective system conditions.
severity
Command Default
All severity levels (from 0 to 6) are logged.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
This command specifies the event severity necessary for alarm messages to be logged. Severity levels can be
specified by the severity level description (for example, warnings). When a severity level is specified, events
of equal or lower severity level are also written to the logging events buffer.
Events of lower severity level represent events of higher importance.Note
This table lists the system severity levels and their corresponding numeric values, and describes the
corresponding system condition.
Table 2: Alarm Severity Levels for Event Logging
Logged System MessagesNumeric ValueSeverity Level Keyword
System is unusable.0emergencies
Critical system condition exists
requiring immediate action.
1alerts
Critical system condition exists.2critical
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 31
Alarm Management and Logging Correlation Commands
logging events level

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English