Cisco XR 1200 series User Manual

verify-data
To check each IP SLA response for corruption, use the verify-data command in the appropriate configuration
mode. To disable data corruption checking, use the no form of this command.
verify-data
no verify-data
Syntax Description
This command has no keywords or arguments.
Command Default
The verify-data command is disabled.
Command Modes
IP SLA UDP echo configuration
IP SLA UDP jitter configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the verify-data command in IP SLA UDP jitter configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# verify-data
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
294 OL-24735-01
IP Service Level Agreement Commands
verify-data

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English