Cisco XR 1200 series User Manual

filter
To define the type of information that are kept in the history table for the IP SLA operation, use the filter
command in IP SLA operation history configuration mode. To unset the history filter, use the no form of this
command.
filter {all| failures}
no filter
Syntax Description
Stores history data for all operations, if set.all
Stores data for operations that failed, if set.failures
Command Default
The default is not to collect the history unless the filter command is enabled.
Command Modes
IP SLA operation history configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
The filter command is supported only to configure the following operations:
•
IP SLA ICMP path-echo
•
IP SLA ICMP echo
•
IP SLA UDP echo
If you use the no form of the filter command, the history statistics are not collected.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the filter command in IP SLA UDP echo configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
140 OL-24735-01
IP Service Level Agreement Commands
filter

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English