Cisco XR 1200 series User Manual

type udp jitter
To use the UDP jitter operation type, use the type udp jitter command in IP SLA operation configuration
mode. To remove the operation, use the no form of this command.
type udp jitter
no type udp jitter
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
IP SLA operation configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the type udp jitter command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)#
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 291
IP Service Level Agreement Commands
type udp jitter

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English