Address Table Commands 101
Address Table Commands
bridge address
The bridge address Interface Configuration (VLAN) mode command adds a MAC-layer station
source address to the bridge table. Use the no form of this command to delete the MAC address.
Syntax
•
bridge address
mac-address
{
ethernet
interface
|
port-channel
port-channel-number
} [
permanent
|
delete-on-reset | delete-on-timeout | secure
]
•
no bridge address
[
mac-address
]
•
mac-address
— A valid MAC address.
•
interface —
A valid Ethernet port.
•
port-channel-number —
A valid port-channel number.
•
permanent —
The address can only be deleted by the
no bridge address
command.
•
delete-on-reset
— The address is deleted after reset.
•
delete-on-timeout —
The
address is deleted after "age out" time has expired.
•
secure
— The address is deleted after the port changes mode to unlock learning (
no port
security
command). This parameter is only available when the port is in the learning locked
mode.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
• Using the
no
form of the command without specifying a MAC address deletes all static
MAC addresses belonging to this VLAN.
book.book Page 101 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
