Spanning-Tree Commands 357
Spanning-Tree Commands
spanning-tree
The spanning-tree Global Configuration mode command enables spanning-tree functionality.
Use the no form of this command to disable spanning-tree functionality.
Syntax
• spanning-tree
• no spanning-tree
Default Configuration
Spanning-tree is enabled.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example enables spanning-tree functionality.
spanning-tree mode
The spanning-tree mode Global Configuration mode command configures the spanning-tree
protocol. Use the no form of this command to return to the default configuration.
Console(config)# spanning-tree
book.book Page 357 Thursday, December 18, 2008 7:40 PM