LACP Commands 231
LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the system priority.
Use the no form of this command to return to the default configuration.
Syntax
•
lacp system-priority
value
• no lacp system-priority
•
value
— Specifies system priority value. (Range: 1 - 65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
lacp port-priority
The lacp port-priority Interface Configuration (Ethernet) mode command configures physical port
priority. Use the no form of this command to return to the default configuration.
Syntax
•
lacp port-priority
value
• no lacp port-priority
•
value
— Specifies port priority. (Range: 1 - 65535)
Console(config)# lacp system-priority 120
book.book Page 231 Thursday, December 18, 2008 7:40 PM