LACP Commands 233
Example
The following example assigns a long administrative LACP timeout to Ethernet port 1/e6 .
show lacp ethernet
The show lacp ethernet Privileged EXEC mode command displays LACP information for Ethernet ports.
Syntax
•
show lacp ethernet
interface
[
parameters
|
statistics
|
protocol-state
]
•
interface
— Valid Ethernet port. (Full syntax:
unit/port
)
•
parameters
— Link aggregation parameter information.
•
statistics
— Link aggregation statistics information.
•
protocol-state
— Link aggregation protocol-state information.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example display LACP information for Ethernet port 1/e1.
Console(config)# interface ethernet 1/e6
Console(config-if)# lacp timeout long
Console# show lacp ethernet 1/e1
Port 1/e1 LACP parameters:
Actor
system priority: 1
system mac addr: 00:00:12:34:56:78
port Admin key: 30
book.book Page 233 Thursday, December 18, 2008 7:40 PM