EasyManuals Logo

Dell PowerConnect 3524 User Manual

Dell PowerConnect 3524
538 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #531 background imageLoading...
Page #531 background image
802.1x Commands 531
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although only tagged packets are
accepted in the unauthorized state.)
Examples
The following example enables access to the VLAN to unauthorized devices.
dot1x multiple-hosts
The dot1x multiple-hosts Interface Configuration mode command enables multiple hosts (clients) on
an 802.1X-authorized port, where the authorization state of the port is set to auto. Use the no form of
this command to return to the default configuration.
Syntax
dot1x multiple-hosts
no dot1x multiple-hosts
Default Configuration
Multiple hosts are disabled.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
This command enables the attachment of multiple clients to a single 802.1X-enabled port. In this
mode, only one of the attached hosts must be successfully authorized for all hosts to be granted
network access. If the port becomes unauthorized, all attached clients are denied access to the
network.
For unauthenticated VLANs, multiple hosts are always enabled.
Multiple-hosts must be enabled to enable port security on the port.
Console(config-if)# dot1x auth-not-req
book.book Page 531 Thursday, December 18, 2008 7:40 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 3524 and is the answer not in the manual?

Dell PowerConnect 3524 Specifications

General IconGeneral
Throughput9.5 Mpps
Number of queues4
MAC address table8000 entries
Maximum data transfer rate0.1 Gbit/s
Supported data transfer rates10/100 Mbps
10G supportNo
Number of VLANs256
Flow control supportYes
Networking standardsIEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.3ad
Input frequency50/60 Hz
Weight (imperial)11 lbs
Dimensions (WxDxH)440 x 257 x 43.2 mm
Networking featuresGigabit Ethernet, Fast Ethernet
Authentication methodRADIUS, TACACS+
Connectivity technologyWired
Dimensions (W x D x H) (imperial)17.3 x 10.12 x 1.7 \
Switch typeManaged
Switch layerL2
Data link protocolsEthernet
Supported network protocolsHTTP, HTTPS/SSL, SSH
Power connectorDC-in jack
Gigabit Ethernet (copper) ports quantity2
Basic switching RJ-45 Ethernet ports quantity24
Product colorBlack
Power sourceAC
Input voltage100 - 240 V
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)10 - 95 %
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Weight5000 g

Related product manuals