Address Table Commands 117
show bridge multicast filtering
The show bridge multicast filtering Privileged EXEC mode command displays the Multicast filtering
configuration.
Syntax
•
show bridge multicast filtering
vlan-id
•
vlan_id —
A valid VLAN ID value.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the Multicast configuration for VLAN 1.
Console # show bridge multicast filtering 1
Filtering: Enabled
VLAN: 1
Port Static Status
------- ----------------- -----------
1/e14 Forbidden Filter
1/e15 Forward Forward(s)
1/e16 - Forward(d)
book.book Page 117 Thursday, December 18, 2008 7:40 PM