Tunnel 457
tunnel isatap solicitation-interval
The tunnel isatap solicitation-interval Global Configuration
mode
command configures the interval
between ISATAP router solicitations messages (when there is no active ISATAP router). Use the no form
of this command to return to default.
Syntax
•
tunnel isatap solicitation-interval
seconds
• no tunnel isatap solicitation-interval
•
seconds
— Specify the number of seconds between ISATAP router solicitations messages.
(Range: 10 – 3600)
Default Configuration
10 seconds.
Command Mode
Global Configuration mode.
User Guidelines
This command determines the interval of Router Solicitation messages when there is no active ISATAP
router. When there is an active ISATAP router, the robustness level that is set by the tunnel isatap
robustness global configuration command determines the refresh rate.
Example
The following example configures the interval between ISATAP router solicitations messages to 60
seconds.
Console (config)# tunnel isatap solicitation-interval 60
book.book Page 457 Thursday, December 18, 2008 7:40 PM