232 LACP Commands
Default Configuration
The default port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example defines the priority of Ethernet port 1/e6 as 247.
lacp timeout
The lacp timeout Interface Configuration (Ethernet) mode command assigns an administrative LACP
timeout. Use the no form of this command to return to the default configuration.
Syntax
•
lacp timeout
{
long | short
}
• no lacp timeout
•
long
— Specifies the long timeout value.
•
short
— Specifies the short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Console(config)# interface ethernet 1/e6
Console(config-if)# lacp port-priority 247
book.book Page 232 Thursday, December 18, 2008 7:40 PM