216 IPv6 Addressing
Example
The following example
displays
the IPv6 ICMP error interval setting..
ipv6 address
The ipv6 address Interface Configuration mode command configures an IPv6 address for an interface.
use the no form of this command to remove the address from the interface.
Syntax
•
ipv6 address
ipv6-address/prefix-length
[
eui-64
] [
anycast
]
•
no ipv6 address
[
ipv6-address/prefix-length
] [
eui-64
]
•
ipv6-address
— The IPv6 network assigned to the interface. The address is specified in
hexadecimal using 16-bit values between colons.
•
prefix-length
— The length of the IPv6 prefix. A decimal value that indicates how many of the
high-order contiguous bits of the address comprise the prefix (the network portion of the address).
A slash mark must precede the decimal. (Range:
3-128 only 64 when the eui-64 parameter is
used)
•
eui-64
— Specifies to build an interface ID in the low order 64 bits of the IPv6 address based on
the interface MAC address.
•
anycast
— Indicates that this address is an anycast address.
Default Configuration
No IP address is defined for the interface.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. Cannot be configured for a range of
interfaces (range context).
User Guidelines
• If the value specified for the
/prefix-length
argument is greater than 64 bits, the prefix bits have
precedence over the interface ID.
• Using the
no ipv6 address
command without arguments removes all manually configured IPv6
addresses from an interface, including link local manually configured addresses.
Console> show ipv6 icmp error-interval
Rate limit interval: 100 ms
Bucket size: 10 tokens
book.book Page 216 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
