Garmin G1000 Pilot’s Guide for the Diamond DA42NG
190-00962-04 Rev. A202
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
Press the FMS Knob to activate the cursor, and turn the FMS Knob to highlight ‘ACTIVATE?’. Press the ENT Key
to activate the flight plan.
Or:
Press the MENU Key, select ‘Activate Flight Plan’, and press the ENT Key to activate the flight plan.
5) The pending flight plan becomes the active flight plan and is removed from the Flight Plan Catalog Page.
Deleting a pending flight plan:
1) Press the FPL Key and turn the small FMS Knob to display the Flight Plan Catalog Page.
2) Press the FMS Knob to activate the cursor, and turn the FMS Knob to highlight the desired pending flight plan.
3) Select the DELETE Softkey; press the CLR Key; or press the MENU Key, highlight ‘Delete Flight Plan’, and press
the ENT Key. The ‘Delete Flight Plan XX?’ window is displayed.
4) With ‘OK’ highlighted, press the ENT Key to delete the pending flight plan. To cancel the request, press the CLR
Key, or highlight ‘CANCEL’ and press the ENT Key.
Deleting all pending flight plans:
1) Press the FPL Key and turn the small FMS Knob to display the Flight Plan Catalog Page.
2) Press the MENU Key.
3) Highlight ‘Delete All Pending’ and press the ENT Key. A ‘Delete all pending flight plans?’ confirmation window
is displayed.
4) With ‘OK’ highlighted, press the ENT Key to delete all pending flight plans. To cancel the request, press the
CLR Key, or highlight ‘CANCEL’ and press the ENT Key.
ADDING WAYPOINTS TO AN EXISTING FLIGHT PLAN
Waypoints can be added to the active flight plan or any stored flight plan. Choose the flight plan, select the
desired point of insertion, enter the waypoint, and it is added in front of the selected waypoint. Flight plans are
limited to 100 waypoints (including waypoints within airways and procedures). If the number of waypoints in
the flight plan exceeds 100, the message “Flight plan is full. Remove unnecessary waypoints.” appears and the
new waypoint(s) are not added to the flight plan.