Garmin G1000 Pilot’s Guide for the Diamond DA42NG
190-00962-04 Rev. A42
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
The G1000 records the time at which departure occurs, depending on whether the pilot prefers the time
to be recorded from system power-up or from aircraft lift off. The displayed departure time can also be reset
to display the current time at the point of reset. The format in which the time is displayed is controlled
from the System Setup Page.
Setting the departure timer starting criterion:
1) Use the FMS Knob to select the AUX - Utility Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight the field next to the departure time.
4) Turn the
small FMS
Knob to select the starting criterion (PWR-ON or IN-AIR) and press the
ENT
Key.
Resetting the departure time:
1) Use the FMS Knob to select the AUX - Utility Page.
2) Press the
MENU
Key.
3) Use the FMS Knob to highlight ‘Reset Departure Time’ and press the
ENT
Key.
ELECTRONIC CHECKLISTS
NOTE: The checklists presented in this section are for example only and may not reflect checklists actually
available for the Diamond DA42NG. The information described in this section is not intended to replace the
checklist information described in the AFM or the Pilot Safety and Warning Supplements document.
NOTE: Garmin is not responsible for the content of checklists. Checklists are created by the aircraft
manufacturer. Modifications or updates to the checklists are coordinated through the aircraft manufacturer.
The user cannot edit these checklists.
The MFD is able to display optional electronic checklists which allow a pilot to quickly find the proper
procedure on the ground and during each phase of flight. The G1000 accesses the checklists from an SD card
inserted into the bezel slot (see Figure 1-3). If the SD card contains an invalid checklist file or no checklist, the
Power-up Screen displays ‘Invalid Checklist File’ or ‘Checklist File Not Present’ and the CHKLIST Softkey is
not available.
To Next Page
Loading...
Need help?
General
