190-00962-04 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA42NG
605
ADDITIONAL FEATURES
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
8.10 ELECTRONIC CHECKLISTS
NOTE: The optional checklists presented here are for example only and may differ from checklists available
for the DA42NG. The information described in this section is not intended to replace the checklist information
described in the POH.
NOTE: Garmin is not responsible for the content of checklists. Checklists are created by the aircraft
manufacturer. Modifications or updates to the checklists are coordinated through the aircraft manufacturer.
The user cannot edit these checklists.
The optional checklist functions are displayed on two levels of softkeys that are available on any MFD page.
Figure 8-106 Checklist Softkeys
CHKLIST
DCLTR
ENGINE
MAP
The CHECK Softkey label changes to UNCHECK
when the checklist item is already checked.
EXIT
CHECKENGINE
EMERGCY
SHW CHRT
RETURN
The MFD is able to display optional electronic checklists which allow the pilot to quickly find the proper
procedure on the ground and during each phase of flight. The system accesses the checklists from an SD card
inserted into the top card slot of the MFD. If the SD card contains an invalid checklist file or no checklist,
the Power-up Page messages display ‘Checklist File: Invalid’ or ‘Checklist File: N/A’ (not available) and the
CHKLIST Softkey is not available.
The following colors are used for checklist items:
• Light Blue ‑ Items not selected or checked
• White ‑ Item is selected
• Green ‑ Item has been checked
• Gray ‑ General notes
• Yellow ‑ Caution notes
• Red ‑ Warning notes
Accessing and navigating checklists:
1) From any page on the MFD, select the CHKLIST Softkey or turn the large FMS Knob to select the Checklist Page.
2) Turn the large FMS Knob to select the ‘GROUP’ field.
3) Turn the small FMS Knob to select the desired procedure and press the ENT Key.
4) Turn the large FMS Knob to select the ‘CHECKLIST’ field.
5) Turn the small FMS Knob to select the desired checklist and press the ENT Key. The selected checklist item is
indicated with white text surrounded by a white box.
To Next Page
Loading...
Need help?
General
