6-4
GTN 725/750 Pilot’s Guide
190-01007-03 Rev. C
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
6.2 Selecting a Departure
A Departure Procedure (DP) is loaded at the departure airport in the flight
plan. Only one departure can be loaded at a time in a flight plan. If a departure
is loaded when another departure is already in the active flight plan, the new
departure replaces the previous departure. The route is defined by selection of a
departure, the transition waypoint, and a runway.
NOTE: Vector-only departures are not available in the Procedures database
as the GTN 7XX cannot provide navigational guidance on vectored legs.
1. Touch the PROC key on the Home page and then touch the
Departure key to display the Departure list.
2. If necessary, touch the Airport key and enter the departure
airport. Touch the key for the desired Departure.
Touch To Select
Desired Departure
Figure 6-2 List for Selecting a Departure
To Next Page
Loading...
Need help?
General