4-10
GTN 725/750 Pilot’s Guide
190-01007-03 Rev. C
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
4.2.1.5 Load Procedures
The Load Procedure selection from the Waypoint Options will start the
Procedures function. See the Procedures section for complete information.
1. On the Active Flight Plan page, touch the desired waypoint in
the flight plan. The Waypoint Options list will be displayed.
2. Touch the Load Procedures key to go to the Procedure
function for adding procedures to the selected flight plan.
Touch to Select an Approach
Touch to Select an Arrival
Touch to Select a Departure
Figure 4-14 Load Procedures Wpt Option
NOTE: For some procedures, due to very small position differences in the
database, consecutive flight plan legs do not match up. The total effect
on navigational guidance is negligible. The LOC BC 14 at KSLE via UBG
shown below is an example of this.
Procedure Flight Plan
Leg Discrepancy
Figure 4-15 Procedure Flight Plan Leg Position Difference
To Next Page
Loading...
Need help?
General