GE Voluson S6 User Manual

Probe Angle 1 Angle 2 Angle 3
linear probes 7 14 20
Remarks:
•
Changing the Gain, Quality, Wall Motion Filter, PRF and 2D+2D/C is only possible in
scan mode.
•
Beam steering is only possible with linear probes and in scan mode.
8.3.2 CF Operation
The CF operations:
•
‘CF Box Position and CF Box Size’ on page 8‐15
•
‘CF Gain Control’ on page 8‐16
•
‘Quality’ on page 8‐40
•
'Wall Motion Filter (WMF)'
on page 8-41
•
'Velocity Range (PRF)'
on page 8-40
•
'Invert'
on page 8-37
•
‘2D + 2D/C’ on page 8‐16
•
'Threshold'
on page 8-40
8.3.2.1 CF Box Position and CF Box Size
In 2D imaging the relationship between 2D frame rate, line density, and field-of-view are well
known factors to be considered to obtain optimum 2D images. Similar relationships exist in
Color imaging. On the CF Submenu the selection of the Quality adjusts the balance between
the 2D Line Density and the Color mode line density. The values available are scan head-
dependent.
The ability to change the CF box size and position provides flexibility in CF imaging. The
trackball changes the CF box size and position.
Adjust the CF box position on the 2D image with the trackball (in Single, Dual, or Quad mode).
← → CF box horizontal position
↑ ↓ CF box vertical position
The box is adjustable within the entire 2D image area.
The upper trackball key changes between CF box position and CF box size and vice versa.
↑ decrease the vertical CF box size ↓ increase the vertical CF box size
→ increase the horizontal CF box size ← decrease the horizontal CF box size
Doppler Modes
8-14
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4

GE Voluson S6 Specifications

General

Brand	GE
Model	Voluson S6
Category	Diagnostic Equipment
Language	English