Note
It is possible to select which user program shall be started when a new exam is created.
Setting – Application:
1.
Select a program button and press [Set] (labeling area and cursor are displayed inside).
2. Enter a new program label using keyboard or overwrite the existing label or don’t change
an existing program label, if the same term is desired.
3. Select [Save] or [Save&Exit]. The program parameters are saved in the database.
Exit: Back to the last active menu without saving.
Delete: To delete stored settings from the database.
Save: To save settings with the active Settings select menu.
Return: Back to the User Setting main menu.
Default: A change of the default setting is protected by a password. The User cannot change
the label “Default”.
13.2.3.2.3 To Save a 3D/4D Program
This tool saves current 3D/4D settings of the system under a 3D/4D program key.
1. Select the [3D/4D programs] button (in the System Setup – User Settings page).
Note
Only available after a 3D acquisition.
Utilities and System Setup
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 13-21
To Next Page
Loading...
Need help?
General
