11.2.11 MSK Calculations
There are no measurements/calculations specified for application “MSK”.
11.2.11.1 Items of MSK Calculations
There are no items specified for application “MSK”.
11.2.11.2 Before starting MSK Calculations
1. Press the [Patient] key on the control panel, select the [MSK] page and enter all patient
information for MSK calculations. For details refer to: Entering Patient Data
(chapter
'Entering
Patient Data'
on page 4-10
)
Note
To cancel all calculations performed before and to start new measurement, press this key and
select [End Exam] or [Clear Exam].
2. Press [Start Exam].
3. Make sure that the probe and application are selected properly. If another application is
selected, press the [Probe]
key on the control panel, and change it to MSK. For details refer to:
Probe/Program Selection
(chapter
'Probe/Program Selection'
on page 4-7
)
11.2.11.3 MSK - Worksheet
For application “MSK”, there is no specific worksheet available.
Measurements and Patient Worksheets (Reports)
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 11-97
To Next Page
Loading...
Need help?
General
