The trackball has two functions: position and size of the Volume box. The activated function
is displayed in status bar area on the monitor.
Press the upper trackball key to change the function of the trackball from position to size or
vice versa.
7. Change the size of the Volume box by moving the trackball.
Moving:
↑ decrease the box size in vertical direction
↓ increase the box size in vertical direction
→ increase the box size in horizontal direction
← decrease the box size in horizontal direction
8. Select the Quality. This function changes the line density against acquisition speed.
9. To start the VCI-A acquisition press the [Freeze] key or the right trackball key (Start ->
displayed in Status bar area on the monitor).
The volume acquisition starts and the acquired images are displayed.
10. Press the [Freeze] key again to stop the acquisition.
'After the VCI-A Acquisition'
on page
9-102
9.8.1 VCI-A Controls
For further controls and possible adjustments, review 4D Controls
(chapter
'4D Controls'
on
page 9-92
)
.
For Inversion Render mode, see 'Render Mode - Image Type and Render Algorithm'
on page
9-72
Volume Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 9-101
To Next Page
Loading...
Need help?
General
