Note
When both modes are possible and the user changes from complete mode to fast mode a
dialog will appear, saying: It is highly recommended to use complete erase mode to avoid
problems with the DVD/CD. Do you really want to use the fast erase mode?
13.2.6 Backup
There are 2 tabs on the Backup page.
System Configuration 'System Configuration'
on page 13-47
Image Archive 'Image Archive'
on page 13-56
13.2.6.1 System Configuration
The “System Configuration” page is subdivided in three main groups:
Image Settings Only
Save Image Settings Only
(chapter
'General'
on page 13-15
)
Load Image Settings Only
(chapter
'Load Image Settings Only'
on page 13-48
)
Full System Configuration
Save Full SC
(chapter
'Save Full System Configuration'
on page 13-50
)
Load Full SC
(chapter
'Load Full System Configuration'
on page 13-53
)
Delete Full SC
(chapter
'Delete Full System Configuration'
on page 13-55
)
The Image Settings and/or Full System Configuration can be saved to the following
destinations:
•
D partition of internal hard disk
•
DVD/CD+(R)W
•
MOD (if present)
•
Mapped Network Drive Z review:
Map Network Drive
(
'Connectivity'
on page 13-30
)
•
Any other drive connected to the system (e.g.; an external USB-hard disk)
Note
This function is only available in the Full Backup utility. review: Working with external USB-
Devices (chapter
'Working with external USB-Devices'
on page 13-56 )
Do not disconnect an external USB-device without stopping it. Disconnecting without stopping
can lead to data loss on the external device.
Utilities and System Setup
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 13-47
To Next Page
Loading...
Need help?
General
