In the “VOCAL - Edit” menu:
1.
the contours can be manipulated; review:
Modifying a Contour
(chapter
'Modifying a
Contour'
on page 9-125
)
2. a shell contour is generated; review:
Defining a Shell contour
(chapter
'Defining a Shell
contour (shell geometry)'
on page 9-126
)
The shell contour is accepted and stored. The VOCAL - Static 3D menu
(review:
chapter
'VOCAL - Static 3D'
on page 9-127
)
appears on the menu
area.
The shell contour is not accepted and you return to the “VOCAL Modes”
menu, where you can define a new contour.
9.12.5.1 Modifying a Contour
When moving the trackball the dots change to yellow with respect to the position of the cursor.
If the cursor is positioned close to the contour line only one dot is yellow. By increasing the
distance, more dots become yellow.
1. Press the upper trackball key and move the yellow dots by using the trackball. Press the
upper trackball key again to store the modified contour.
2. Repeat these steps if necessary. All relevant results (shell contour, volume etc.) are
updated automatically.
Volume Mode
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4 9-125
To Next Page
Loading...
Need help?
General
