For further details, review: Application Parameters
(chapter
'The Measure Setup Pages'
on
page 11-109
)
•
Depending on the setting in the Measure Setup:
•
all previously set measuring marks are erased when activating cine mode.
•
a new cursor appears to repeat the measurement, or not
•
the caliper (the last measuring mark of the current measurement) is fixed when
pressing the [Freeze] key, the [Print A] or [Print B] keys, [Save] key, etc., or not
For further details, review:
Global Parameters
(chapter
'The Measure Setup Pages'
on page
11-109
)
•
Moreover, many display properties depend on the setting in the Measure Setup.
For
Example: cursor and font of measurement result is displayed in small, medium or large
size
For further adjustments and detailed information review: Global Parameters
(chapter
'The
Measure Setup Pages'
on page 11-109
)
By means of these keys, the mode can be changed and the corresponding measurements will
be shown in the menu area on the screen.
To review, modify, print, etc. the “application dependent” Patient Worksheet, press the [Report]
key on the control panel. For further details, review: Basic Patient Worksheet Functions
(chapter
'Basic Patient Worksheet Functions'
on page 11-101
)
.
Using this flip switch control, the side to be measured can be changed. (e.g., to change from
the left to the right Kidney).
Using this flip switch control, the position to be measured can be changed. (e.g., to change
from mid to proximal or to distal Aorta)
Measurements and Patient Worksheets (Reports)
11-100
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4
To Next Page
Loading...
Need help?
General
