7: TSP command reference Series 2600B System SourceMeter® Instrument
7-2 2600BS-901-01 Rev. C / August 2016
Placeholder text
This manual uses italicized text to represent the parts of remote commands that must be replaced by
user specified values. The following examples show typical uses of italicized text:
Example 1:
gpib.address = address
Where:
address is an integer (0 to 30) that you specify. For example, to set this attribute to 15 you would
send:
gpib.address = 15
Example 2:
digio.trigger[N].assert()
Where:
N is an integer (1 to 14) that you specify. For example, to assert trigger line 7 you would send:
digio.trigger[7].assert()
To assert a trigger line with a variable as the integer, you would send:
triggerline = 7
digio.trigger[triggerline].assert()
Example 3:
smuX.trigger.measure.Y(rbuffer)
Where:
X refers to the source-measure unit (SMU) channel (use a for SMU A).
Y is the measurement type that you specify (v, i, r, or p).
rbuffer is the reading buffer object where the readings will be stored.
For example, to use SMU A to take voltage measurements and store them in buffer vbuffername,
you would send:
smua.trigger.measure.v(vbuffername)
To Next Page
Loading...
Need help?
General
