Keithley 2600B User Manual

Series 2600B
System SourceMeter® Instrument Reference Manual Section 7:
TSP command reference
2600BS-901-01 Rev. C / August 2016 7-151
Details
Set flag to one of the following values:
true: Enable automatic line frequency detection at start-up.
false: Disable automatic line frequency detection at start-up.
When this attribute is set to true, the power line frequency is detected automatically the next time
the Series 2600B powers up. After the power line frequency is automatically detected at power-up,
the localnode.linefreq attribute will be set automatically to 50 or 60.
If the localnode.linefreq attribute is explicitly set, localnode.autolinefreq will be
automatically set to false.
When using this command from a remote node, localnode should be replaced with the node
reference, for example node[5].autolinefreq.
Also see
localnode.linefreq (on page 7-152)
localnode.description
This attribute stores a user-defined description and mDNS service name of the instrument.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Not applicable
Nonvolatile memory
Instrument specific (see Details)
Usage
localnode.description = description
description = localnode.description
description
User-defined description and mDNS service name of the instrument; use a string of
63 characters or less
Details
This attribute stores a string that contains a description of the instrument. This value appears on
instrument's LXI welcome page. The value of this attribute is also used as the instrument's mDNS
service name.
This attribute's factory default value is "Keithley Instruments SMU <model number> - <serial
number>", where <model number> and <serial number> are replaced with the actual model number
and serial number of the instrument. Setting this attribute to an empty string (in other words, setting
this attribute to a string of length zero, or one consisting entirely of whitespace characters) will revert
the description to the factory default value.
When using this command from a remote node, localnode should be replaced with the node
reference, for example node[5].description.
Example
description = "System in Lab 05"
localnode.description = description
Set description to "System in Lab 05".
Also see
None

Keithley 2600B Specifications

General

Brand	Keithley
Model	2600B
Category	Measuring Instruments
Language	English