Keithley 2600B User Manual

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-52 2600BS-901-01 Rev. C / August 2016
Example
MaxCount = dataqueue.CAPACITY
while dataqueue.count < MaxCount do
dataqueue.add(1)
end
print("There are " .. dataqueue.count
.. " items in the data queue")
dataqueue.clear()
print("There are " .. dataqueue.count
.. " items in the data queue")
This example fills the data queue and prints the
number of items in the queue. It then clears the
queue and prints the number of items again.
Output:
There are 128 items in the data queue
There are 0 items in the data queue
Also see
dataqueue.add() (on page 7-49)
dataqueue.CAPACITY (on page 7-50)
dataqueue.clear() (on page 7-51)
dataqueue.next() (on page 7-52)
dataqueue.next()
This function removes the next entry from the data queue.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
value = dataqueue.next()
value = dataqueue.next(timeout)
value
The next entry in the data queue
timeout
The number of seconds to wait for data in the queue
Details
If the data queue is empty, the function waits up to the timeout value.
If data is not available in the data queue before the timeout expires, the return value is nil.
The entries in the data queue are removed in first-in, first-out (FIFO) order.
If the value is a table, a duplicate of the original table and any subtables is made. The duplicate table
does not contain any references to the original table or to any subtables.

Keithley 2600B Specifications

General

Brand	Keithley
Model	2600B
Category	Measuring Instruments
Language	English