7: TSP command reference Series 2600B System SourceMeter® Instrument
7-310 2600BS-901-01 Rev. C / August 2016
Also see
Operation Status Registers (on page E-9)
status.operation.instrument.smuX.* (on page 7-306)
status.operation.instrument.trigger_blender.*
This attribute contains the operation status trigger blender summary register set.
Type TSP-Link accessible Affected by Where saved Default value
.event (R) Yes Status reset Not saved 0
Usage
operationRegister = status.operation.instrument.trigger_blender.condition
operationRegister = status.operation.instrument.trigger_blender.enable
operationRegister = status.operation.instrument.trigger_blender.event
operationRegister = status.operation.instrument.trigger_blender.ntr
operationRegister = status.operation.instrument.trigger_blender.ptr
status.operation.instrument.trigger_blender.enable = operationRegister
status.operation.instrument.trigger_blender.ntr = operationRegister
status.operation.instrument.trigger_blender.ptr = operationRegister
The status of the operation status trigger blender summary register; a zero (0)
indicates no bits set (also send 0 to clear all bits); the only valid value other than 0 is
Details
These attributes are used to read or write to the operation status trigger blender summary registers.
Reading a status register returns a value. The binary equivalent of the returned value indicates which
register bits are set. The least significant bit of the binary number is bit B0, and the most significant bit
is bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
Status register set
contents (on page E-1) and Enable and transition registers (on page E-19). The individual bits of this
register are defined in the following table.
To Next Page
Loading...
Need help?
General
