Setting Output Methods
6
bizhub PRO 1050P 6-3
6 Setting Output Methods
6.1 Sorting / Stapling Printed Sheets (FS-503 Finisher)
The FS-503 Finisher has a primary (main) tray and a secondary (sub) tray,
each of which has the following output modes.
Output to the Primary (Main) Tray
-
Non-sort:
Non-sort mode simply means that the offset-stacker finisher modes are
not selected. Printed sheets will be stacked upon exit without being off-
set by sorted sets.
-
Collated:
Collated mode outputs multiple sheets of the original set, having each
sorted set offset by 30mm upon exit.
-
Uncollated:
Uncollated mode groups together multiple sheets of each original and
offsets the sets by 30mm upon exit.
-
Staple
:
Staple mode offsets and staples each sorted set.
Combined with the output modes above except staple mode, you can also
choose to output face up or face down, and output front to back or back to
front.
Example:
Make 3 printed sets
from 4 original sheets
Offset by 30mm
Offset by 30mm
1 oblique
staple
2 staples
UncollatedCollatedStapleNon-sort
To Next Page
Loading...
Need help?
General
