12 WHEELS 55
B00744-10
Main work
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change the wheel bearing.
– Clean and grease the shaft seal rings 1 and mating surfaces A of the spacers.
Long-life grease ( p. 250)
– Insert the spacers.
– Clean the thread of the wheel spindle and screw 2.
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
– Mount and tighten screw 2.
Guideline
Screw, front wheel spindle M8 30 Nm
(22.1 lbf ft)
– Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
– Take the motorcycle off of the front wheel stand. ( p. 11)
– Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
– Tighten screws 3.
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
Finishing work
– Take the motorcycle off of the rear wheel stand. ( p. 10)
12.4.3 Removing the brake disc of the front brake
Preparatory work
– Raise the motorcycle with the rear wheel stand. ( p. 10)
– Raise the motorcycle with the front wheel stand. ( p. 10)
– Remove the front wheel. ( p. 54)
304806-10
Main work
– Remove screws 1.
– Remove the brake disc.
12.4.4 Installing the brake disc of the front brake
304806-10
Main work
– Clean the contact surface of the brake disc.
– Position the brake disc with the label facing outward.
– Mount and tighten screws 1.
Guideline
Screw, front brake disc M8 29 Nm
(21.4 lbf ft)
Loctite
®
243â„¢
Finishing work
– Install the front wheel. ( p. 54)
– Take the motorcycle off of the rear wheel stand. ( p. 10)
To Next Page
Loading...
Need help?
General
