To prevent unwarranted warnings, for in-
stance in car washes, turn off automatic
Park Distance Control activation on obsta-
cle detection.
Malfunction
If Park Distance Control malfunc-
tions, the Attention icon appears on
the Interaction Unit.
Depending on vehicle equipment, the sen-
sor detection range may not be shown.
A Check Control message is displayed.
Park Distance Control has failed. Have the
vehicle checked by an authorized service
center or another qualified service center or
repair shop.
Active Park Distance Control
Principle
Active Park Distance Control is the brake
function of Park Distance Control and ini-
tiates emergency braking in the event of an
acute risk of collision.
The system can be used below walking
speed when reversing or coasting back-
ward.
Due to system limits, a collision cannot be
prevented under all circumstances.
Pressing the accelerator pedal interrupts
the brake intervention. Emergency braking
is not performed.
The Interaction Unit can be used to tempo-
rarily deactivate Active Park Distance Con-
trol as well as configure the settings for this
system.
General information
Follow the information in the "Parking as-
sistance systems" chapter.
Safety information
Warning
The system cannot serve as a substitute
for the driver’s personal judgment in as-
sessing the traffic situation. Based on the
limits of the system, it cannot independ-
ently react to all traffic situations. There
is a risk of accident, injury, or property
damage. Adjust driving style to traffic con-
ditions. Watch the surrounding traffic sit-
uation closely, be ready to take over steer-
ing and braking at any time, and actively
intervene where appropriate.
Sensors
Active Park Distance Control is controlled
by the following sensors:
– Ultrasonic sensors in rear bumpers.
– Ultrasonic sensors at the sides.
Driving off after emergency
braking
After emergency braking to a stop, further
creeping toward an obstacle is possible.
Proceed with caution. To move forward,
lightly press the accelerator pedal and re-
lease as needed.
If the accelerator pedal is depressed longer,
the vehicle drives off. Manual braking is
possible at any time.
Deactivating Active Park Distance
Control temporarily
After emergency braking, Active Park Dis-
tance Control can be temporarily deacti-
vated on the Interaction Unit. A correspond-
ing message is displayed.
Go through the menu as follows:
"Configure" / "Deactivate temporarily".
Seite 233
Parking CONTROLS
233
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
